Vacuum Suction Hood

Vacuum Suction Hood
Request a quote

The vacuum suction hood is used to clean the waste produced during the AAC production. It is mounted on the vertical cutting machine or handing hole making machine.

After vertical cutting, the waste material will be collected, and the green cake as well as the side plate will be carried away. The waste material falls into the recycling water groove. Then the semi-finished product elevating device conveys the green cake and side plate onto the hardening car, where the cake will be grouped.

Usually, the waste can’t be wiped out by hand. Staying on the top of the cake, it may stick to the block after the autoclaving curing, and thus lowering the product quality and appearance. By using the vacuum suction hood, you can improve the product quality and qualified rate. In addition, by enhancing waste recycling rate, the product cost can be reduced.
Related Equipment in This Section
Other Products
    1. Auto-mobile Bridge
    2. Auto-mobile BridgeThe bridge trolley at the front and rear of the autoclave is kind of a bridge that overlaps the inner track of autoclave and rail...
    1. Automatic Gas Distribution and Residual Gas Recovery System
    2. Automatic Gas Distribution and Residual Gas Recovery SystemAccording to the set value, the automatic steam distribution system will adjust valve...
    1. Separator
    2. SeparatorTo separate the sticky cakes into several layers, the finished products are blocks or panels. The separator is an important...
    1. Finished Product Clamping Hoist
    2. Finished Product Clamping HoistFinished products will be lifted by clamping hoister, to leave side wall behind, and the side wall will be transferred...
    1. Rotating Hoister
    2. Rotating HoisterFinished squeezed, blocks will be lifted by rotating hoister, on the length 1.2m direction, after 90 degree rotating, the blocks will be put in cross directions on the pallet.