Holding Pin Inserting and Drawing Hoist

Holding Pin Inserting and Drawing Hoist

The holding pin inserting and drawing hoist is a critical machine for the AAC panel manufacturing. It is mounted below the traveling crane which can drive the hoist up and down.

During the AAC panel production, the holding pin inserting and drawing hoist carries the coated reinforcement meshes or cages to an appointed place. Then, the meshed or cages are plugged into the mould by assembling frames and positioned by holding pins. After pre-curing, the holding pin inserting and drawing hoist takes the assembling frames and holding pins out of the mould.

Request a quote
Related Equipment in This Section
Other Products
    1. Vacuum Suction Hood
    2. Vacuum Suction HoodThe vacuum suction hood is used to clean the waste produced during the AAC production. It is mounted on the vertical cutting machine...
    1. Tiling Hoister
    2. Tiling HoisterAfter pre-curing, the mould will be transferred to tiling area. The hoister should grasp mould to rotate it with 90 degrees, then the clamping arm controlled...
    1. Top and Bottom Cleaning System
    2. Top and Bottom Cleaning SystemAfter cutting processing, the waste material retained at the bottom or top of the cake should be recycled into waste pulp...
    1. Traction Mechanism
    2. Traction MechanismThe traction mechanism is very important to the fluent operation of the AAC production line. It can push or haul the mold in the pre-curing section...
    1. Ferry Push Car Before/After Autoclave
    2. Ferry Push Car Before/After AutoclaveThe ferry push car before/after autoclave is located at the autoclaving section of AAC production line. It consists of working station...